CD54/74HC123, CD54/74HCT123, CD74HC423, CD74HCT423
High-Speed CMOS Logic Dual Retriggerable Monostable Multivibrators with Resets

Формат: PDF
Размер: 653 Kb

The 74HC/HCT244 are high-speed Si-gate CMOS device and are pin compatible with low power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A.

Формат: PDF
Размер: 45 Kb

The 74HC/HCT74 are high-speed Si-gate CMOS devices and are pin compatible with low power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A.

Формат: PDF
Размер: 99 Kb

The TL7726 consists of six identical clamping circuits that monitor an input voltage with respect to a reference value, REF. For an input voltage V in the range of GND to REF, the clamping circuits present a very high impedance to ground, drawing current of less than 10 µA. The clamping circuits are active for V GND or V REF when they have a very low impedance and can sink up to 25 mA.

Формат: PDF
Размер: 65 Kb

The TDA7052A/AT are mono BTL output amplifiers with DC volume control. They are designed for use in TV and monitors, but also suitable for battery-fed portable recorders and radios.

Формат: PDF
Размер: 71 Kb

The SN75150 is a monolithic dual line driver designed to satisfy the requirements of the standard interface between data-terminal equipment and data-communication equipment as defined by TIA/EIA-232-F. A rate of 20 kbits/s can be transmitted with a full 2500-pF load. Other applications are in data-transmission systems using relatively short single lines, in level translators, and for driving MOS devices. The logic input is compatible with most TTL families. Operation is from 12-V and –12-V power supplies.

Формат: PDF
Размер: 101 Kb

SN74AHCT1G86 SINGLE 2-INPUT EXCLUSIVE-OR GATE

Формат: PDF
Размер: 75 Kb

These monolithic hex inverter buffers/drivers feature high-voltage open-collector outputs to interface with high-level circuits (such as MOS), or for driving high-current loads, and are also characterized for use as inverter buffers for driving TTL inputs. The LS06 has a rated output voltage of 30 V and the LS16 has a rated output voltage of 15V. The maximum sink current for the SN54LS06 and SN54LS16 is 30 mA and the SN74LS06 and SN74LS16 is 40 mA.

Формат: PDF
Размер: 70 Kb

These octal buffers and line drivers are designed specifically to improve both the performance and density of 3-state memory address drivers, clock drivers, and bus-oriented receivers and transmitters

Формат: PDF
Размер: 356 Kb

SL74HCT04 Hex Inverter High-Performance Silicon-Gate CMOS

Формат: PDF
Размер: 34 Kb

S | Просмотров: 427 | Дата: 04.05.2010 | Комментарии (0)

The LM733/LM733C is a two-stage, differential input, differential output, wide-band video amplifier. The use of internal series-shunt feedback gives wide bandwidth with low phase distortion and high gain stability. Emitter-follower outputs provide a high current drive, low impedance capability. Its 120 MHz bandwidth and selectable gains of 10, 100 and 400, without need for frequency compensation, make it a very useful circuit for memory element drivers, pulse amplifiers, and wide band linear gain stages.

Формат: PDF
Размер: 169 Kb

The L78L00 series of three-terminal positive regulators employ internal current limiting and thermal shutdown, making them essentially indestructible. If adequate heatsinkis provided they can deliver up to 100mA output current.

Формат: PDF
Размер: 148 Kb

AN78Lxx/AN78LxxM Series 3-pin positive output voltage regulator (100 mA type)

Формат: PDF
Размер: 179 Kb

This N-Channel Logic Level MOSFET has been designed specifically to improve the overall efficiency of
DC/DC converters using either synchronous or conventional switching PWM controllers.

Формат: PDF
Размер: 93 Kb

Fifth Generation HEXFETs from International Rectifier utilize advanced processing techniques to achieve
extremely low on-resistance per silicon area. This benefit, combined with the fast switching speed and
ruggedized device design that HEXFET Power MOSFETs are well known for, provides the designer
with an extremely efficient and reliable device for use in a wide variety of applications

Формат: PDF
Размер: 134 Kb

The GD75323 combines five drivers and three receivers from the trade-standard SN75188 and SN75189
bipolar quadruple drivers and receivers, respectively. The flow-through design of the GD75323 decreases the
part count, reduces the board space required, and allows easy interconnection of the UART and serial-port
connector. The all-bipolar circuits and processing of the GD75323 provide a rugged, low-cost solution for this
function.

Формат: PDF
Размер: 158 Kb